AC WORKS® Library

Download: Electric Vehicle Product Sheet

Posted by Stephanie Junek on

AC WORKS™ Electric Vehicle Product Sell Sheet contains compact adapters of all types, flexible adapters, and cord sets to get power to and from just about any combination of items you would need to charge your electric vehicle.  You can charge your EV using many different outlets including regular household outlets, HVAC, Generator, Industrial, RV Power, Range, Dryer, Dock power and more.

Read more →

User Manual: 20 or 30 Ampere Locking Plugs and Connectors

Posted by Stephanie Junek on

1. CABLE: Provide a cable of applicable ampacity, service and temperature rating suitable for the conditions of use and location. The plugs and connectors are designed for use with 3, 4 or 5 conductor cables with a diameter from .375’’ to 1.56” (12/3 SJ through 8/5 S). 2. CORD CLAMP PREP: Gray colored cord clamp inserts preinstalled for use with .550” to .875” cable diameter. If you need other sizes, please contact us. 3. CABLE PREP: Remove out jacket 2” and strip each individual conductor 5/8” as shown in Figure 1 Below. Make sure the wire is clean and bright...

Read more →

Download: Residential Product Sheet

Posted by Stephanie Junek on

Download the AC WORKS™ Residential Power product sell sheet here.

Read more →

User Manual: 15, 20 and 30 Amp Straight-Blade or Locking Inlet

Posted by Stephanie Junek on

1. CABLE: Provide a cable of applicable ampacity, service and temperature rating suitable for the conditions of use and location. The plugs and connectors are designed for use with 3, 4, or 5 conductor cables with a diameter from .375’’ to 1.156’’ (12/3 SJ through 8/5 S). 2. CORD CLAMP PREP: Gray colored cord clamp inserts preinstalled for use with .550’’ to .875’’ cable diameter. For other sizes: A. Loosen and remove the cord clamp assembly from the housing. B. Remove the gray colored cord clamps from the cord clamp assembly. C. Replace with an appropriately supplied cord clamp insert:...

Read more →

User Manual: 30 Amp Inlet Box

Posted by Stephanie Junek on

IMPORTANT! Installation of your AC WORKS™ brand temporary power inlet box and associated wiring must be performed by a licensed electrician in compliance with all applicable codes. Mount the temporary power inlet box in a suitable location using the holes provided in your AC WORKS™ brand inlet box packaging. All wiring methods and materials must conform to NEMA practices. Route the conduit or cable through one of the provided knockouts in the inlet box. Route the cable or conduit to the junction box. All conductors are to be at least 10 AWG but not exceeding 8 AWG.  Include a ground wire...

Read more →